As one of the sanitation equipment, the road sweeper is a new type of efficient cleaning equipment integrating pavement cleaning, garbage recovery and transportation。It can be widely used in highway, municipal and airport pavement, urban residential areas, parks and other road cleaning。Road sweeper can not only clean garbage, but also dust and purify the air medium on the road, which not only ensures the beauty of the road, maintains the health of the environment, maintains the good working condition of the road surface, reduces and prevents the occurrence of traffic accidents and further extends the service life of the road surface。The use of road sweeper for road maintenance has become a trend in China。
Road sweeper cleaning steps:
One: Cleaning work
1 Turn on the power supply of the control box and point the control valve towards the auxiliary valve position
2 Starting auxiliary
3 The auxiliary clutch control button is pointed to the close position, and the fan starts to work
4 Point the box control button to the falling position
5 Point the left or right sweep control button to the falling position
6 Point the left or right sweep rotation control button to the forward rotation position (left clockwise, right counterclockwise)
7Point the left water jet, right water jet and rear water jet control buttons to the open position
8 Point the pump control button to the open position
9 The vehicle travels at a proper speed and begins the sweeping action
Two: The cleaning is over
1 Traffic stop
2 Turn the water pump control button and the left spray control button The right spray control button and the rear spray control button point to the off position
3 Point the broom control knob to the center position
4 Point the sweep control button to the ascending position and then to the middle position
5 Point the vacuum box control button up and then to the center
6 Point the secondary engine clutch control knob to the point, then to the middle position
7 Point the control valve control key to the center position
8 Subengine off
9 Turn off the power to the control box
Three: Unload the garbage
1 Turn on the power to the control box and point the control knob of the control valve towards the position of the main valve
2 Start the vehicle's main engine
3 Depress the vehicle clutch
4 Turn on the oil pump clutch switch attached to the vehicle (pull outward)
5 Release the vehicle clutch at the appropriate speed
6 Point the rear door control button on the control box to the open position,5Then point to the center in a second
7 Point the compartment control button to the lifting position, and point the control key to the middle position at any time according to the tilt Angle of the compartment. At this time, the compartment tilt to lift stops
8 Garbage cleaning
9 After the garbage is cleaned, the control button of the carriage is pointed to the position of the fall, and the control button is pointed to the middle position after the carriage is completely returned
10 Point the back door control to the close position,10Then point to the center in a second
11 Garbage removal End
12 Depress the vehicle clutch
13 Turn off the attached pump clutch control button (push in)
14 Release the vehicle clutch at the appropriate speed
15 Point the control valve of the control box towards the middle position
16 Power off the control box.
Hubei Junlong special car company——Is the National Development and Reform Commission designated production of all kinds of special automobile professional manufacturers, large special automobile factory。Specialized productionAerial work vehicle、Fuelling truck、Garbage truck、Concrete mixer truck、Watering cart、Fire fighting truck,Dirt suction truck、dumper、Flatbed carrier、wrecker、Garbage truckAll kinds of special vehicles such as semi-trailers, as well as domestic well-known landscaping, petrochemical, municipal sanitation vehicle manufacturing。Jiefang, Dongfeng, Auman, the general agent of heavy truck tractor。Company Wealth Hotline:15308664455 网址:wqggge.fozubaoyou.net